trigger guard for my 54cal hawken came in
10-12-2010 | 08:06 AM
#1
Thread Starter
Nontypical Buck
Joined: Aug 2007
Posts: 3,713
Likes: 0
From: Staunton,Va
trigger guard for my 54cal hawken came in
my trigger guard. now the problem is, it comes up short on the back side of the of trigger group. pretty much after shaping it will not drop in the the original trigger guard inlays. thinking about just filling in the inlays and surface mounting the trigger guard.
I will try to get some pics up once I clean the trigger guard up from the left over casting process.
only thing left is to get an rear site and getting the double set trigger to work right. you don't need to set the trigger to get it to fire lol. got an 54cal rb mold just gotta clean it and cast some up.
older pic of the gun.
I will try to get some pics up once I clean the trigger guard up from the left over casting process.
only thing left is to get an rear site and getting the double set trigger to work right. you don't need to set the trigger to get it to fire lol. got an 54cal rb mold just gotta clean it and cast some up.
older pic of the gun.
Last edited by corey012778; 10-12-2010 at 08:39 AM.
10-13-2010 | 06:38 AM
#2
Typical Buck
Joined: Sep 2007
Posts: 697
Likes: 0
From: NE Louisiana
send it back.the folks at caines will talk to you via e-mail. they are very helpful.tell them it won,t fit.they carry enough trigger guards that you should be able to find the right one.
Don,t alter your stock,find what fits.
Don,t alter your stock,find what fits.
