what do you think the turnaround time is on an action if you send it back to TC for a trigger job to be performed?
|
Lil Problem: bellum is no longer doing trigger jobs. Maybe I'll call T/C but suspect that they are not doing a 3pd trigger job if only for liability reasons... so sad :(
|
Originally Posted by onetohunt
(Post 3698646)
what do you think the turnaround time is on an action if you send it back to TC for a trigger job to be performed?
|
I have done several, down load these free instructions. i recommend several things for getting the best results with a minimum of effort and complications. The trigger spring for 2 to 3 pounds has worked the best, I put the heavier hammer spring in for several reasons. Smooth all the mating parts take off the seam [ what usually causes the problem] first with a fine cut needle file then with the AR stone, DO NOT change the angles just smooth the surfaces to glass slickness. For the instructions go to:
http://www.bellmtcs.com/store/index.php?cid=456 |
Originally Posted by lemoyne
(Post 3698944)
I have done several, down load these free instructions. i recommend several things for getting the best results with a minimum of effort and complications. The trigger spring for 2 to 3 pounds has worked the best, I put the heavier hammer spring in for several reasons. Smooth all the mating parts take off the seam [ what usually causes the problem] first with a fine cut needle file then with the AR stone, DO NOT change the angles just smooth the surfaces to glass slickness. For the instructions go to:
http://www.bellmtcs.com/store/index.php?cid=456 I am about to work on my Encore trigger. I downloaded Bellm's instructions. Is the sear really soft enough to cut with a file? |
All times are GMT -8. The time now is 02:21 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.