opps now that might be a proplem.
I got a little issue. Now if tomorrow was a hunting day and not a target day it would be a big issue. I think my muzzleloader might be loaded. SInce i went out last week. Now i worried at first till i thought it was not going to be a hunt i would be ok. Just fire it and see if it is loaded if not i can check to see if i flinch. As i will not know if it is loaded or not. What would you do if a hunt was the next day and you where not sure. I have a triumph could i hold it barrel end down and take out the breech plug and reinsert it if it is loaded without moving the powder.
|
Iam no expert but I would remove the breach plug and if it is loaded get the powder out push the bullet out and reload.
|
Do as most would, put your ram rod in the barrel and see how much is sticking out the end of it, you should be able to remember how the ram rod looks in your loaded ML. If in dout pull the Breechplug and do the Manufactures recommended stepd for removing a loaded barrel.
What I do and have always done is put a pice of Masking Tape over the end of My ML Barrel to keep out moisture, when fired there's no guessing if it has a charge in it or not. But from now on put a mark on your Ram Rod when it's loaded, with the Ram Rod sticking out the end of your loaded barrel, (UN PRIMERED) take a knife or something similar to etch a mark where the Ram Rod meets the top part of your barrel, from now on you'll never have to guess again. (BP) |
Originally Posted by Breechplug
(Post 3520958)
Do as most would, put your ram rod in the barrel and see how much is sticking out the end of it, you should be able to remember how the ram rod looks in your loaded ML. If in dout pull the Breechplug and do the Manufactures recommended stepd for removing a loaded barrel.
What I do and have always done is put a pice of Masking Tape over the end of My ML Barrel to keep out moisture, when fired there's no guessing if it has a charge in it or not. But from now on put a mark on your Ram Rod when it's loaded, with the Ram Rod sticking out the end of your loaded barrel, (UN PRIMERED) take a knife or something similar to etch a mark where the Ram Rod meets the top part of your barrel, from now on you'll never have to guess again. (BP) |
If it's that big of a deal just push the load out and start over.
|
Originally Posted by B BAKER
(Post 3520765)
Iam no expert but I would remove the breach plug and if it is loaded get the powder out push the bullet out and reload.
|
All times are GMT -8. The time now is 07:16 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.