corey012778

does anyone know where I can find an hammer spur for an win apex.

tired of smashing my thumb under my scope.

cayugad

would the hammer spur from a Pursuit work? Does the Apex hammer have a threaded hole in it? Check out the spur on the Traditions Firearms sight.

corey012778

no threaded. very little hammer to began with. at this point, I need to ask how to make something that would work

MountainDevil54

email cva about one. should be the same as the optima.

corey012778

I may do that.

it is my one problem with this one. damn thing puts 2 bullets in the same hole at 50yrds. inch from bulls at 100yrds. groups at 1.5in

MD why did you want to sell this again

MountainDevil54

cuz i wasnt on the proper medication that i am on now

Breechplug

I think it's the same as the CVA Kodiak, no luck with the hammer....have you tried see-thru mounts to raise the scope??

corey012778

have an email out to cva on it.

I am not a big fan of see thru mounts. look for some extra high may do it too, but I have it set up great for me. [8D]

may go with an shorter scope. depends on what happens with something else. got my eye on a couple that may work better then the rifle scope I have on it now.

dmurphy317

Been there done that. There is no hammer spur for the Apex. Think about it, if there was a hammer spur, you would not be able to drop the action and prime it. That's why they dont have one for it. At least that's BPI/CVA's answer to the question.

I've thought about designing a swiveling spur that could be attached to the hammer so it could swing out of the way when dropping the action but have not had time to dig into it.

corey012778

so going for the shorter scope or play with the placement of the scope