HuntingNet.com Forums

HuntingNet.com Forums (https://www.huntingnet.com/forum/)
-   Black Powder (https://www.huntingnet.com/forum/black-powder-23/)
-   -   tc new englander front sight (https://www.huntingnet.com/forum/black-powder/275903-tc-new-englander-front-sight.html)

corey012778 11-28-2008 09:56 PM

tc new englander front sight
 
I am trying switch out the front sight on my new englander. I got an front sight from track of the wolf.

Problem is I can't get the old one off. been pounding on it 3 hours and only got to move very little. any ideas on what could be holding it on?

putting something on that will allow me to pick up the target better.

cayugad 11-28-2008 09:59 PM

RE: tc new englander front sight
 
They only go in and out of the wedge one way. Are you maybe trying to drive it out the wrong way?

corey012778 11-28-2008 10:14 PM

RE: tc new englander front sight
 
been doing from the right side. try it from the left tomorrow.


mountaineer magic 11-29-2008 12:38 PM

RE: tc new englander front sight
 

ORIGINAL: corey012778

been doing from the right side. try it from the left tomorrow.
I don't have a T/C NE but on my Lymans they all have sights that must be put on from right to left and removed left to right.

thumper50 11-29-2008 04:49 PM

RE: tc new englander front sight
 
i HAVE READ AND HEARD, AS A GENERAL RULE in =rt to left, out left to rt!!

corey012778 11-29-2008 05:21 PM

RE: tc new englander front sight
 
got it, i am not going into details on how. lets just say I got an bigger hammer.;)

Chasam60 11-29-2008 05:33 PM

RE: tc new englander front sight
 
I hope you did not "bend" the barrel

Charlie

corey012778 11-29-2008 05:40 PM

RE: tc new englander front sight
 
hope not either.


getting the new one in is a little easier. almost have it. just gotta do some tapping with an punch

liquidorange 11-29-2008 07:00 PM

RE: tc new englander front sight
 
you need to put something like electrical tape around the barrel just in case you miss while hitting it. i dont think it matters which side it is knocked out from . you need to get a small lump hammer. you need weight and heavy impact to get that sight off.when you tap the new one in go slow and use a brass punch checking often to see if its lines up where you need it to be. you may also want to use the round part of a ballpein hammer to just lightly tap the edges over before tapping in the new sight. take your time and good luck!


All times are GMT -8. The time now is 03:12 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.