I was going to start doing a little work on the stock but that is going to hold off until I shoot it. it is going to see alot of conicals.

off hand does anyone know the twist?

1:48

thanks, I just found it on a site I was looking on, about the sametime I saw that[8D]

My NewEnglander like short conicals. I just got a mould for the Lee 250gr REAL and so far it looks very promising in the NewEnglander. The 1:48 twist is a compromise for PRB & conicals and I find it's fairly good for PRB but not ideal. For conicals the shorter designs do much better than a long bullet..................
of course ever barrel has it's own tastes and yours may make me out to be wrong. [:'(]

yeah, I got a lot of work.

btw I desided to refinish the stock tonite. there was nothing on tv.

Dont get in a rush, I finally finished the rear part of the GPR's stock a few days ago. Pretty much now just have to finish up the lock area and then fine sand and then oil the stock. Then rebrown everything.

started sorry, forgot to say that part. got the old finish off,

ever used wood bleach? I plan on giving it a try when the new "big one" comes in and then just hit it with some 400 grit.

this is my second over all wood finishing job. my first was a sword rack that I never got hung. lol

so no.

[:@]grrr, I got a rusted screw in the but plate. I would had to take it to a gunsmith just to take that screw out anyone have any idea getting it out. I am going to have to hit an hard ware store to find a replacement.[:@]