![]() |
Attention Idaho Inliners.
Look what I made today. And it freicking works too!!!! Idaho legal inline conversion for my Whites. This type of thing could be adapted to a lot of different inline guns.
Need to fashion a spring to keep the "Hammer" against the "Plunger". Just went to WallyWorld and bought a pack of diaper pins, I think I kin make a spring from one a those. Started with a piece of 1/8"x2" hot roll flat stock, hack sawed it into an L, put it in the drill vice and heated it with a tourch and bent it into form. Was nice to have this POS Luisiana rust bucket barrel I got stuck with from an on line auction, to use as a mandrel to bend the orange hot metal around the round part. Been tinkerin with it since lunch. Need to polish it a bit and file the top edge level. Then I need to decide what to do for a finish. Could try to cold blue it or just paint it. ![]() ![]() ![]() ![]() |
RE: Attention Idaho Inliners.
goatbrother
Isn't it the craps we are forced to do something like this - but is does say "pivoting Hammer" certainly looks that way to me.... |
RE: Attention Idaho Inliners.
ORIGINAL: goatbrother Look what I made today. And it freicking works too!!!! Idaho legal inline conversion for my Whites. This type of thing could be adapted to a lot of different inline guns. Need to fashion a spring to keep the "Hammer" against the "Plunger". Just went to WallyWorld and bought a pack of diaper pins, I think I kin make a spring from one a those. Started with a piece of 1/8"x2" hot roll flat stock, hack sawed it into an L, put it in the drill vice and heated it with a tourch and bent it into form. Was nice to have this POS Luisiana rust bucket barrel I got stuck with from an on line auction, to use as a mandrel to bend the orange hot metal around the round part. Been tinkerin with it since lunch. Need to polish it a bit and file the top edge level. Then I need to decide what to do for a finish. Could try to cold blue it or just paint it. http://www.williamsgunsight.com/gunsights/813usedblkpowderguns.htm SS with scope and sabots for $195, sounds like a deal to me. Chap |
RE: Attention Idaho Inliners.
Are you actually shooting that rifle?
|
RE: Attention Idaho Inliners.
Heck no I ain't shootin that rifle. That is just a junk piece of iron that a fine upstanding gentelman from New Orelens sold me in an internet auction, he said the bore was perfect and no rust. NO RUST!!! As you can see the barrel is no longer fit to be a gun, ain't even got any rifling left inside. But it worked just fine as a pattern for fitting the IDAHO TRAD CONVERSION.
|
RE: Attention Idaho Inliners.
Looks like hurricane katrina got it:D
|
RE: Attention Idaho Inliners.
Pre Katrina, by about three weeks. I hope that sorry slob that sold it to me had lots of problems after Katrina flooded him out.
|
RE: Attention Idaho Inliners.
This will be a little easier on the eyes.
![]() ![]() |
RE: Attention Idaho Inliners.
Good job...nowthat's what I'd call progress! :D
Maybe you'd liketofreshen up that rifling now? |
RE: Attention Idaho Inliners.
ORIGINAL: gleason.chapman SS with scope and sabots for $195, sounds like a deal to me. Chap |
| All times are GMT -8. The time now is 09:29 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.