Length of BS .504 500 grain conical
 

What is the length of the 500 grain conicals you guys have been shootin in your White's?

RE: Length of BS .504 500 grain conical
 

I measured them a while back and I remember them being a hair under 1". If I remember, I will measure again tonight and let you know what the exact dimension is. If you order some of the BS's for your White, I would highly recommend asking Dan to make them at .5045". They will load very easy and in my mind engrave a little better than the .504".

RE: Length of BS .504 500 grain conical
 

Sorry, forgot to bring my calipers home from work. Measured it again with tape measure and was right at 1" or maybe a hair less.

RE: Length of BS .504 500 grain conical
 

Thanks cascadad, I think I'll get some. I'm limited to length 2 times diameter. Actually, I need them in .5015 as my land to land is .501 in the NEF sidekick. I actually don't mind a little tightness starting, in your opinion, is 1 thousandth oversize too tight for reasonable loading?

Phil

RE: Length of BS .504 500 grain conical
 

Phil

Poster Underclocked has the NEF. He shoots big conicals -- even the BullShops. Send Rich a private message for best fit in most NEF bores.

RE: Length of BS .504 500 grain conical
 

Give UC a try to see if he has advise. If you want you could always email Dan at

[email protected]

He might be willing to send you a sample of different diameters to try in your barrel. That way you are sure you are getting what you want when you order. He does a great job and even with shipping from AK, they are very economical. Pretty sure the shipping is the same on orders up to about 500 bullets. If you get a sample and find the one you like and place a big order, it will come out to about 22 or 23 cents each.

Your postman might ask you, "What is in that box, lead?" You just say, "Yup.":)

RE: Length of BS .504 500 grain conical
 

Sorry, but the only bullet I have ever tried (and still use) in the Huntsman is a 400 grain PR Bullet Ultimate 1 hp. I have never slugged that rifle's bore either, so can't really say which size from Bull Shop you would need. It SHOULD be .502 as that was the H&R spec that I recall reading somewhere, but check anyway.

In .50x caliber, any of Dan's bullets of 500 grains or less will be western state legal (less than 2X).