Replacement ramrod
01-07-2006 | 10:13 PM
#32
Nontypical Buck
Joined: Feb 2003
Posts: 3,092
Likes: 0
RE: Replacement ramrod
I've got one of Cain's Hunter Super Rods in 7/16" diameter. Was setup for .50 cal but I turned down one end to accept a .45 jag. Makes for a very good bench rod.
Don't think you coud tie it in a knot though.
Don't think you coud tie it in a knot though.
01-07-2006 | 10:30 PM
#33
Boone & Crockett
Joined: Aug 2004
Posts: 11,703
Likes: 0
From: Idaho
RE: Replacement ramrod
Underclocked
Apparently not if you are offering a challenge - but I wasn't talking about the "super rod" i don't think - I was talking about the "space age" plastic ones that I have. It is called a Rugged Ramrod -- made of "space-age plastic".
Remember Underclocked - i am on your side... most anytime you and Randy are having one of your discussions!
Apparently not if you are offering a challenge - but I wasn't talking about the "super rod" i don't think - I was talking about the "space age" plastic ones that I have. It is called a Rugged Ramrod -- made of "space-age plastic".
Remember Underclocked - i am on your side... most anytime you and Randy are having one of your discussions!
01-08-2006 | 09:56 AM
#34
Nontypical Buck
Joined: Feb 2003
Posts: 3,092
Likes: 0
RE: Replacement ramrod
Ha! 
Yep, I've noticed that. And no, no challenge offered - just meant the thing is pretty stiff. I've had a couple of those "jelly" rods you were talking about..... HAD being the operative word.
Yep, I've noticed that. And no, no challenge offered - just meant the thing is pretty stiff. I've had a couple of those "jelly" rods you were talking about..... HAD being the operative word.
