deer-hunter18,
The main thing is start with timing your cam. This is done by twisting your cable and both ends of your string. Check your timing holes in your cam and see if they are parallel with your string.Twisting your cable on the cam end will rotate your cam clockwise. Twisting the string equal amounts on each end will rotate the cam counter clockwise. Once your cam is timed checked all your specs with the limb bolts bottomed out. You can then make minor changes in the cable and string to bring the other measurements in spec. Keep in mind. Twisting your cable adds draw weight, and increases draw length. Twisting your string does the opposite, decreses draw weight and draw length., so it is a combination of these that will get your specs back in.