I just bought an LX, but I am waiting on a cam to come in(27" 80%). I have shot a max-cam bow for quite a while, so all I know about the LX is what I have been able to read, so bear with me if I seem to not know what is up. Anyway, Let's say I want to use something smaller than the stock draw stop rubber dealie. Will that not increase the draw length by a little? If so, and I adjust it to 65%, will the slight increase in draw also increase the percent let-off? I plan on using a D-loop, so my concern is that at 27", the draw may end up slightly too long. As I have been shooting the low let-off max cam for quite a while, I am not too worried about dropping down to 26.5", but it would be comforting to know that I may be able to get a slightly longer draw and a bit higher let-off by using something skinny on the draw stop. Thanks for any advice or clarifications.