I finally finished off the top of my garage to be my "dog house" Set up the reloading area and thought I would check out the strength of the bench on a few of the 444 cases I got off ebay. Didi the FL size and assembled the Lee case length trimmer and found it would not fit into the resized neck. Didnt have time to go over all the variables as I had a 4 hour ride home to start. Question is should I run the case length proceedure prior to the the case FL sizing? Or do I have a bad cutter? I am taking the mic back up on my next trip as I needed it here to measure up a flyrod blank.