HuntingNet.com Forums - View Single Post - AXIS ST Arrows

06-03-2004 | 03:44 PM

#1

Len in Maryland

Joined: Feb 2003

Posts: 1,385

Likes: 0

From: Baltimore Maryland USA

AXIS ST Arrows - update.

We did some more impact tests on the AXIS STs with the 'HIT' inserts. We had tested them with PowerBond and 5 minute epoxy, which is what we use on all our carbon arrows. The insert didn't hold on impact. I was told by the Rep that the factory 'highly' recommends using 24 hour epoxy. Should have read the instructions thoroughly. [

]

We did the 24 hour epoxy and now they hold up as good as a standard insert using PowerBond; but, it takes extra measures for the 'HIT' to equal standard epoxy or PowerBond on standard inserts.

So, if you're going to use the AXIS ST arrows, make sure you use the epoxy supplied and INSIST on a 24 hour epoxy from your Dealer if you're not sure.

One thing I pointed out to the Rep is that any loose point could be catastrophic. Therefore, there are two major points I recommend in using the AXIS ST arrows over other all carbon arrows if you want the best results:
1) You MUST use 24 hour epoxy
2) You MUST keep your tips tight

Hope this helps.

Reply

0