Originally Posted by
54bore
Mike, Did you Lube the Bullet before resizing? Makes a HUGE difference!! Anything over .002 and i Roll them across a Lube Pad, They Go Through effortlessly, and ZERO finning. I go as far as to “Pre Lube” the inside of the Sizing Die before i get Started, I use a Qtip with Lube on it and Coat the Sizing Ring of the Die. A job that took a Hard Pull on the Press Handle, Just became easy enough to do with 1 finger!!
Thanks Lou, I have re-sized these bullet both ways - with lube and without. Really doesn't make much difference. Resizing from 458 to 4535 is very easy. Then resizing the 4535 to 451 is really not difficult at all. Resizing from 458 to 451 is more difficult but nothing really difficult.