The flash hole on the Impact is .029

The flash hole on the primer adapter on the strike is .034. This I do not like. The strike comes with two primer adapters, one for loose powder, the second for pellets. The one for pellets would ignite both pellets and loose powder. Anyway, I measured the extra primer adapter at .033. I sure hope before I started the loose powder adapter was .034, I would not think wear that fast.

I think I'm going to switch adapters and shoot the one for pellets with loose powder. The Primer adapter did stick like MD said with BH209. You just stick the rod in and pop out, it's pretty easy but not right. But it's sticking cause so much crud gets in behind it. The adapter needs to meet a wall to keep this from happening. I might try putting grease or something next time. I also need to test this ignition system with 777 as much as I hate to say that.