Testing the custom flintlock in the heat
It got hot here today. 82 degrees hot. And there was a strong wind. But when you have a mind to shoot, you just have to shoot. All the chores done, so I pulled out the .54 caliber custom made Early Lancaster .54 caliber flintlock. This rifle has a 42 inch Swamped Colerain barrel and a Seiler lock on it. Its lock time is amazing, as is the trigger.
I set a target out at 50 yards. (as far as I like to walk when its hot) My load was 90 grains of 2f Schuetzen Black Powder, a home cast .535 roundball, pillow tick patch, moose milk lube, and 4f as the prime. With a new Thomas Fuller Black English Flint in the lock, ignition was almost instantaneous. You'd of thought you were shooting a modern center fire. *I was swabbing between shots with Dollar Store Windex and two dry patches afterward.
First three shots were just a half inch over the bulls eye and could have been covered with a large quarter or a small fifty cent piece. Number 4 then had to jump two inches to the right and low for some reason. It could have been the cast job on the bullet, maybe the barrel was not cleaned as well as it should have. Who really knows. It probably was me anticipating the shot as I was getting pretty full of myself. Number 5 was just under the main group, in the bulls eye. The next four hits made the main hole connect to #5 and make a large hole in the center of the target.
Then for kicks I put up two paint cans at 88 yards. Back off the shoot block I aimed dead center on them. The first can flipped impressively into the air. But when I checked it, the hit was actually low, just up from the bottom edge of the can. The second can was hit dead center in the can, which made me happy.
I have discovered that with old age, and eye surgery, I really have lost the ability to shoot long distance with open sights on my flintlocks. I personally think the cans were lucky. But I was able to hit them again when I tried.
Over all it was just nice to get out and shoot my rifle. What a great rifle Tennessee Valley Arms built for me. And I am going out on a limb here. Those that think cleaning a real black powder rifle is hard. I just don't see it. Granted it don't take five minutes, but I have a few extra minutes to enjoy the rifle and all it takes to protect it.