Seems like you're digging up old threads about Boyd's stocks just to bash them. This thread is ~9yrs old, the other one you posted on today was 12yrs old... Both of these posts making up your only two posts to this forum.

I can say that I have not had the same experience with Boyd's customer service. Yes, if you ordered the wrong stock, there is a restocking fee for exchanges, and they will not replace it if you have altered the stock in any way. That's on you for ordering the wrong stock. I have contacted them with questions to ensure I received the right stock for my application, even negotiated a "you're telling me this fits, if it doesn't, you foot the shipping bill" agreement with them. Wasn't an issue, since they were right, it fit.

It is also intentional that they ship stocks with the inlet at minimum tolerance. There's nothing you can do with a stock if it's too loose, can't put wood back on. But ANYONE can run sandpaper. This is a common practice in the stock making industry.

Here's a snippet from boyd's page:

Definitions of BOYDS' Finished, Unfinished and Semi-Inlet Stocks

(FINISHED)

Factory fit and finished references stocks that have been 100% fit and sanded to our house action, then finished with one of Boyds' superior finishes. Factory Fit stocks can be pulled from the box and bolted to your firearm with no fitting; however, on occasion, sight variations of individual guns may occur, requiring slight fitting that a novice should be able to perform. Please consult a competent and qualified gunsmith if you need assistance. A competent and qualified gunsmith is defined as a person who, at a minimum, works for your firearm manufacturers warranty or service center OR a person who has had 10 years or more of gunstock installation experience and has graduated from a gunsmith college with at least a two-year Associate Arts & Science (A.A.S.) degree in gunsmithing.

House Actions

House actions refer to the steel we use to fit and finish our gunstocks. It is quite common to find variations in the metal of like firearms. Therefore, for our fitting purposes, we try to choose the metal smallest in size to help assist in machining a product that is aesthetically appealing on all receivers. When machining barrel channels, unless stated otherwise, we will use the manufacturer's standard sporter barrel. When machining Mauser actions, Boyds' will typically use a #1 contour barrel.

So both of these paragraphs mention that they cut the inlets to a "minimum specification".

This is also a snippet from their Returns section of their "Policies" link...

Please inspect product within 10 days of receipt to insure that you have received the proper stock and that it is free from defects. Natural cosmetic imperfections such as minor knots, burls, heartwood, mineral lines or minor cosmetic fill work are not considered a defect and will be subject to the 12% restocking fee. Factory seconds are purchased as is and cannot be returned. If you receive the wrong stock please call customer service. If for any other reason a return is required, a 12% restocking fee will be imposed and shipping fees will not be reimbursed. Alterations to your stock and/or forend of any kind, will void any and all warranty and the return of your part will not be allowed. Proof of purchase must accompany all returns.