HuntingNet.com Forums - View Single Post - Help Needed - Knight Disc Bolt Problem
Thread: Help Needed - Knight Disc Bolt Problem
View Single Post
Old 09-04-2011 | 04:18 PM
  #2  
sabotloader's Avatar
sabotloader
Boone & Crockett
 
Joined: Aug 2004
Posts: 11,703
Likes: 0
From: Idaho
Default
Originally Posted by Josmund
I was shooting the Disc Elite with Lehigh Conversion. The very fist shot the STS primer would not eject. In hindsight, I should have just dry fired it because I'm sure the 90 grains of BH209 pushed part of the primer back into the pin hole. Before I could reassemble the bolt I got it jacked up to where I can't line it up. It appears to be in the fire position but I can't turn it left or right. Pics Below:







Suggestions on getting out of this mess? I can't be the first one to have this issue. Thanks in advance.
I think you can fix your problem by just turning the secondary safety in... it will get tight and then it will pull the hammer back and allow you spin the internal mechanism to the correct spot.
The only problem could be it is is a C tool bolt and that may require a bit more work...

Looking ath the bolt I do not think it is a C tool so it should be pretty easy to fix.

Have you ever taken the bolt apart before to clean it or anyrhing?
sabotloader is offline  
Reply
0