MountainDevil54

I am going to ask a dumb question and nothing bad is ment by it. When you drilled the the CVA plug, did you pick the flash hole clean. possibly blow the pug out with air? Dumber question you did not drill it all the way through did you?

I am serious about this mail me the plug let me run a #21 bit all the way through it and install a vent liner... i actually would really like you to try it. I can not do anything about the head space because I do not know what the OAL of the plug with the primer installed should be. If I knew that i could also set your head space.

I am asking this a fellow ML shooter and that is all. What I would really like to do is modify a CVA QR plug and have you test that. The one thing you have to be careful of is not to ding the nose since it is a compression fit to your bore.