Originally Posted by
chetmarks
received the followng email this morning., noticed it included a disclaimer.:
Chet,
Thank you for the e-mail. Yes, I did tell him it was OK. IN THIS CASE, this type of primer charge will not increase pressures or cause a negative effect. You might think of it as a kin to the black powder charge pressed in the bottom of a pyrodex pellet or even a flash pan powder that ignites the primary charge in a flint lock.
Best regards,
Don Luhr
Western Powders
Ramshot/Accurate Powders
Tel: (406) 234-0422 email: [email protected]
Western Powders Inc -- Miles City – Montana.
Western Powders Inc. disclaims all possible liability for damages including, actual, incidental and consequential, resulting from usage of the information or advice contained in this message.
Use the data and advice at your own risk, and with extreme caution.
We also request that you visit our websites www.accuratepowder.com www.ramshot.com www.montanaxtreme.com or www.blackhorn209.com for more comprehensive information.
IMPORTANT NOTE: Always begin loading from the minimum "START charge and carefully develop loads by increasing in small increments of 2% towards the Maximum load.
If that isnt enough to satisfy the trolls i dunno what is.