so bh tunning has never, ever worked for me regardless of the bh (fixed bh's). during pig season i had to just dial in the bh and not get them to hit with my fp's. well trying to get ride of the rage bh's and move to the slicks i started over and did the following:
put on rest, QAD, and made it so that fork of the rest would hold my arrow at the holes were you screw in the rest on the side of the bow. i ensured the qad was set up correctly with the string attached to the down cable.
drew back the bow to where it felt comfortable and put the tube peep there
put on the sight
measured 3/8 inch above square on the string with the qad at full draw.
tried bare shaft tunning....no avail
did walk back tunning...got it good, then tried to shoot the bh at 20 and it was way off
went straight to bh tunning. at first i was hitting left and low. i adjust the rest and lower my knocking point.
finally get the bh and fp to hit good left to right, but the bh is still hitting low about 6"
continue to slowing move the knocking point and now i have it so i am hitting only about 1" low at 20 and 2" low at 30??
then i look at my knocking point and it is probably 3/8" BELOW square are full draw???? WTF!!!!
i can't figure this crap out, i understand it and make adjustments accordingly but it never pans out!....could it just be my bow or?????
specs just in case you don't remember: parker hunter mag extreme 67#, 100gr slick trick, 30" and 30" carbon express terminator lite 60/75