Sabotloader,I have both of the conversions and am using the Precision version.I was thinking that I would use the Lavaltrie version to do what you did.I think that I would like to weld the slot that is holding the spring shut and toss the spring.

I am using the CCI M primers and they don't seat to the flange,on both version really.Did you have this issue or does your conversion press the primer into place?The Precision version is tighter than the Lavaltrie.I reamed the pocket some but I didn't want to make the fit sloppy so I just made it so the primer seats abit deeper but still not to the flange.Do you think it would hurt to ream it further so it seats flush but tight?

On your unit it looks like you turned the hammer back to make the firing pin?How far back did you go and what is the diameter of the pin?How much did you take off the bolt?How does the pin set to the face of the bushing,is it flush or recessed some?

Sorry for all the questions! thanks, nmaineron