Originally Posted by bigcountry

Cam lean would cause that. But so would a bad serving job or busted serving. You only have to bust one strand of the serving for it to do what your seeing. But you are correct, cam lean can too.

Basically if your cam leans one way or another thru out the draw cycle, its leaning. Can be caused by improperly installed strings/cables, bad limbs, inconsistently limbs, riser warp, limb pockets, axles, you name it. But it most likely is simply you need to adjust the split bus cable depending ont the bow.

To check for, you can eye ball it, use a level, or use a spott hogg laser tool. Which I love.