Allegiance Cam synch ?
So I finally dropped the money to get a bow press. Got the Omni Press and it works great.
I figured it was time after what is considered one of the best bow shops in NJ bent the riser and put the spacers on my Darton Typhoon wrong. Then when I get my limbs replaced on the Allegiance. (my fault why they needed replacing) They put the cables on wrong so the module frays the strands.
I built a draw board this weekend and am having issues getting the cams in synch. It is shooting bullet holes through paper.
The bottom cam is hitting the cam draw stop 1/8" before the top. My question is do I twist tighter the cable that attaches to the front of the bottom cam or back off twists? Another question is that all of the measurements are to spec but the bow bottomed out is at 67lbs for 60-70lb peak. I would like to get it all back to spec.
Thanks in advance! [/align]