Brad.

Check your PM's

Ok back on track.

Once you have marked the center line of the riser place your drilling jig on and drill 2 holes in each end 1 1/4" and the other 15/32".



Then with a 1/2" tap carefully tap the 15/32" holes.



Then mix up a little epoxy and place a small amount onto the threaded insert.



Now using a locking nut and one of the limb botls screw the insert into position so it is just below flush.



Wipe off excess epoxy and place the riser into the heat box for an hour or so.



I decided to go ahead and cut out the sight window and shelf.



Had a couple of splinters pull out near the insert and another one at the shelf as you can see by my hand[:@]

I should be able to glue the one by my hand back into place before I start the final shaping



Here is the Bubinga side.



From the back.



Thats all I can do now till the glass arrives, I was notified that it was shipped today because of the holiday yesterday so it should be here in 2/3 days.