ORIGINAL: monster6
This is only a rough estimate. im at work so i dont quite remember well but i do remember measuring and geting close to these measurments.
From base to tip = 14.5 inches both sides
1 brow=1 1/2
2nd brow = 2
base circumference= 2 inches. both sides
Lol!! I don't think you know where to measure on a rack. The H1 measurements are way off. You measure at the smallest point between the G1 and the burr at the smallest point. You wrap the tape all the way around the beam In the particular spot, not across It. There at the smallest 3.5", I'm thinking 4".
I figure this buck to be at about 100".