Geez. That ain't no good. Hw long have you been dealing with them on that ? Were they drilled crooked, or just to much slop to cause the axles to float around in the hole ?
ORIGINAL: KodiakArcher
Problem is that with a binary cam system there is no yoke to twist and the cam was rubbing the inside of the limb. They were feeding me a line that cam lean is designed into the binary cam until I told them about the cam rubbing. Then they back tracked and admitted there was a problem. The culprit was mis-drilled axle holes on both the upper and lower limb. Solution: new limbs, which BowTech made every excuse not to send, and still hasn't.