Larry,
I understand what your saying. However, after a case has been fired, it has a bulge about 1/8" up from the head. That case will not rechamber. I put black marker on the cases to make sure of the catch point and that is it. When I run the case thru my resize die, it will only size it to this ridge. The shellhoder is bottomed out.
BUT, last night I tried something. After resizing once, I removed the expander/deprimer pin, re-lubed, set the die well below cam-over and ran a few cases thru it. I was able to get a little farther down the case that way. These cases would chamber. This is good, but a lot of extra work and obviously shouldn' t be necessary.
Any thoughts on this?.....Thanks