This is not my strong point, So you string/cable twisting experts feel free to chime in.

I have some strange (to me) measurements on my 03 single cam Pat, and need some direction

Limbs bottomed out (my scale is busted) this is what I get.

> Brace height - 7.5, should be 7.25

> A-A is 34.00, should be 33.75

>Cam masurement from
CL of screw to Limb .375 should be .215 it is under rotated

>Draw length AMO 30" should be 29"

>Draw stop is on the 6th mark from the L with a #2 pat module. This is according to manual correct to achieve 80% letoff and 29" draw.

Both the string and cable measure within a 16th of an inch to specs. I nailed one end to my deck and pulled as hard as I could with a rod in the other end.


I would like to get the cam screw measurement correct and shorten the draw 1/2" .

What should I do???????????