statjunk

Discovered another issue last night with my set up.

Usually when I'm seating the bullets into the case I start big and turn the die down until the bullet measures 3.40 to 3.98. Something in that window. I then seat the rest of the bullets. Well I decided to measure the next bullet. It measured down to 3.93. After some trial and error I could not get the seater to seat the bullets to a uniform size. I'm using a Redding Bullet Seating die.

Another thing though I don't think it's that big of a deal but all my brass is trimmed to 2.605 instead of 2.61.

So how big of a deal are the two things above?

Some additional info is that I'm seating the bullets to fit in the magazine. So I'm way off the lands.

Thanks

Tom