Exactly,and if you put twist in the cable,that puts it(cable) back in spec and rotates the cam back.THEN,you put twist in the string and it puts it(string) back in spec and at the same time,rotates the cam back forward.The marks should align at this point.


They work opposite of each other when they are twisted,just have to keep the right amount of twist in each to keep them from getting too far out.


I know it seems odd that you untwisted the strings and cables to get it back to your marks but it really isn't.I know you got it back to your marks but threw it out of sinc in the process.


Looks like the module is pretty flat,that is what I would set it up to.Pull it back and see if you are flat on the module to set the timing.Make sure the a-a and brace is correct,then do a little creep tuning to see if it does any good.Being a 1 cam it might not but then again,it might.