Alright, I finally received my replacement part for my press, so I could get back to work on timing my cams on my 101st. Well, I got them to where they are just missing the cables when the o-ring is completely compressed. Problem is now the cables are not sitting in the center of the cable stop channels. In fact, as I draw the bow back, you can hear the edge of the cable clipping the outside edge of the cable stop. I have absolutely no idea why this is happening, but I can assume it's not good. Below, I've included pictures of the cams at full draw so you can see what I'm talking about:

Bottom Cam:



Top Cam:



Any suggestions?