So, I made a post here the other day about my 101st ATA and brace height being incorrect, and was instructed to take my strings/cables off and measure them. I found them to be all slighlty longer than the factory specs state. Today, I was able to use a j-hook fastened into a floor joist to draw back the bow and check the cam timing. Below I included pictures of the cams at full draw, and to me, it seemed the cams were hitting the cables at the same time and were rotating at the same speed. The only issue I think I might have is my draw stop peg is hitting too late (slightly after the draw stops hit the cables). Would this cause a very shallow valley? Reason I ask is if I creep even the slightest bit, the bow wants to yank my shoulder out of socket. I attributed a lot of it to the cam aggresivness, but I still think it could be improved. This is all new territory to me, so any advice would be appreciated. Take a look at the pictures and tell me if anything stands out that needs adjusting. Thanks.

Top Cam Closeup:





Bottom Cam Closeup:




Top Cam Whole Shot:




Bottom Cam Whole Shot: