Or should I say Dog-gone bow setter upper [:-]

I have spent two nights trying to stop fletching contact, and just can' t see it happening. Looking for some advise. Already sent an e-mail to trophy-taker and waiting a response.

Set up - 67# 2003 bowtech single patriot, 29" draw, string loop, release, short bar shakey hunter, 4" feathers and 4" vanes, both 5575 and 7595 GT XT' s.

I have set it up to raise from the last 3 " to the last 1/4" . I have moved it up and down (with nocking point).

With cock feather down I get heavy contact from the V in the cradle, almost to where the arm is welded. It hits pretty good.

Cock feather up, the inside down feather nails the tab the knot is tied on too.

I can only get clear with a 1 to 2 " nock high tear, and get bullet holes with bare shaft when set correctly - but feathers hit!

I don' t want to use the bungy - even if it will help.

The cradle rests nice and flat on the shelf.

Any advice??????????