ORIGINAL: Arthur P
This is a cast magnesium riser
I must not have been paying attention if you said that before. I thought you were talking about a machined aluminum riser! Cast magnesium... I think I'd be drawing up the seat of my drawers in a serious pucker when drawing it ifthat thingneeded a lot of straightening. Watch for cracks!
I think I said that but maybe I didn't.That is why I was taking it a LITTLE at a time.The cast process has gotten MUCH better so that is the only reason I attempted it AND I told him it may crack or break.
Roskoe,a 1/4" is about right.I figured it was bent about .075 to .100 and I went about that much past center so a 1/4" is pretty close.
I have a couple weeks to pay him so I can watch it and see if it moves.
