Ok, I changed out my MZE to a QAD ultra LD. I love the QAD. Its on my bowtech liberty. I changed out my limbs not too long ago, and new winner choice string.

Ok, I start off paper tuning and I have to push the rest towards the riser. Way towards the riser or I will get a nock left tear!!!

I go out and bare shaft tune and only way to get it right is to move the rest towards the riser. If I set it to center by eyeballing or laser, it shows a weak arrow condition. I know this is not the issue, because I can set the bow to 60lbs or 70lbs and get this same weak arrow condition. So I tried two different arrows, beman black max 340 and carbon express Edge CX 350. Same deal.

I know there is no clearance issues, I check and check again.

I then move to broadhead tune and also get great flight and broadheads line up with field points all the way out to 50 yards if I move the rest towards the riser.

Now the normal thing I know to do when my broadheads group way right of my field points is move the rest away from the riser. But that makes it worse.

So what I am saying is the bow is shooting better than it ever has, broadheads and field points are hitting same POI out to 50-60 yards, and I am getting awesome groups out there, but I have to move my rest way towards my riser.

I never did get a great tune with the MZE and hated getting cable wear from it. Only way to getclearance I needed to cross cable over the slide. And had to change out my limbs and can't go back.