HuntingNet.com Forums - View Single Post - New ML
Thread: New ML
View Single Post
Old 01-06-2008 | 04:25 PM
  #11  
gleason.chapman
Nontypical Buck
 
Joined: Dec 2005
Posts: 3,246
Likes: 0
From:
Default RE: New ML/ one more question

ORIGINAL: little-d

i have a atec simmons on mine in 2.8x10x44 so far its been good. before mississippi laws would pemit scopes i used the zero x pentax it was great for shooting paper plates but when i hit the woods the deer that came by at 50 yrds looked like ants i got one but only cause it stood there long enough to let me look over the scope about ten times to make sure thats what i was aiming at, after that i went without untill i got that red dot after i missed a few using that i took it off in the woods and said the heck with all that stuff and went with open sights till the magnacation was allowed. once you get that new gun broke in you will like it, just don't get mad cause its to hard to load, just keep a slege hammer in you pocket to hammer them first few hundred rounds down into the bottom.
If your GUN LOADS hard your using the WRONG SABOT for your bore size. Buy some MMP HPH12, HPH24 and 3petel EZ and some Harvester Crushed Rib sabots and get the right sabot for your bore.
It should go down tight, but NOT pound it down tight. Loose is dangerous and looses accuracy.
Chap Gleason

gleason.chapman is offline  
Reply