HuntingNet.com Forums - View Single Post - 270 brass just a necked down 30-06?
View Single Post
Old 12-31-2007, 02:22 PM
  #6  
bigcountry
Guest
 
Posts: n/a
Default RE: 270 brass just a necked down 30-06?

I have done it before, but you have to be careful about neck thickness. If you necks get thicker than .015 or so, you have to neck turn. But that depends on your chamber. You might have a very loose chamber where you neck goes in. But it could be very tight. A gunsmith can cast your chamber to see, or you can try it with 270 dies and by hand push a piece of brass with a bullet seated (I suggest no powder at this point), and see if it seats easily.

Point I am getting at is, you might want to just sell or trade your 06 brass.