No, did not watch the DVD yet. However, I got an installation document enclosed (1 sheet - front and back). It showed a diagram of the Dissipator bar and clear instructions to take it appart? It said to take (2) 5/16" limb screws and (4) #10 recoil plate screws out. The #10 screws do not have a wrench that fits (looks like sometype of smallhex head)? Then you replace the existing screws with longer ones which are enclosed (for recoil plate). Last thing you do is put the pads on. Maybe I should watch the video but why would they put this document inside the box, (4) allen type wrenchs and longer screws? I think this should have been done at the factory! The pads I can see doing - due to the fact they explained you need to have the bow strung before putting on the pads.