gopherfan

I do remove the barreled action form the stock to clean and to do the hot soapy water treatment. I do not remove the scope but I am pretty careful not to get it invloved in the hot water treatment. If you have 'quick detachable' mounts and you trust them remove the scope.

I remove the breech plug assembly.

I also clean the firing pin assembly... the block that comes up covers the 209 primer... Their are a couple of types of assemblies... Wolfhound did some schematic drawings of these assemblies. I have the one for mine but I did not save the other. You could PM Wolfhound and asked him for a copy of his drawings - if yours is not like mine.

I do not remove the trigger assembly but I do flush it re-lubricate it.

I do clean the inside of the stock...

After cleaning the barreled and lubricating the trigger I will lubricate the complete underside of the barreled action then install it back in the stock and complete the clenaing job...

Hope some of this helps....