Curtis,

You do not need that 5th pin with the ME model.You can move the bottom pin down for multiple settings using the knob on the side. This means you never need more than the 4 pins and actually have about 8 pins in 1.

For my bow each full turn isabout 4-5yds of distance. At a 3D shoot Monday we shot at 1 target at 60 yds. My bottom pin is sighted in at 50 yds. So, I went2 clicks down and was on the money.

Therefore,save your money on the LE and buy the Fitz Fibers. I need to take some pictures of my Fitz set-up outside and I'll post them.

The only issue I have with mine isI overcranked the adjustment screw while the pin was locked down and stripped the adjustment a little bit and the screw will not "tighten" into place and vibrates a little. not a big deal though. A little blue loktite did the trick.

I'd recommend that anyone that buys this sight go to their local hardware store and buy the smallest lock washers they have and put them on the hold down screws for the pins. The screws tend to work loose and if you are heavy handed like me you will break a screw off. I had to replace one and when I did i added the lockwashers and have not had a single problem since.

Frank,

If you have me end up needed me to order the sight for you I will include the lockwashers. I'll even put them on the sight for you.