RE: Stinkin' Whiffen Tool
Kip,
No need to buy a jig for tapers. Simply take a 1X2X5", (approximate- nearly any size will do), piece of oak or some other wood. Get a long drill bit, and drill a hole at 90º the long way through the wood. Mark a line at that same 90º. Then using a protractor mark a new
line 5º from the first. Band saw that 5º line, leaving the line. Use your disc sander to sand smooth to the 5º line. Clamp the board to your sander table and put the arrow in the hole. Do another at 11½º. Mark them 5º for the point taper and 11½º for the nock.