there could be some serious liability in what you ask. Buy a simple starter kit, and a manual. go slow, one stage at a time. reloading is easy and fun. there are really only a couple of steps. some vary the order but the steps don't change

1. resize and deprime
2. clean the brass, primer pocket included
3. chamfer the case mouth
4. re prime
5. add a carefully measured amount of powder under the maximum
load advertised
6. seat the bullet.

Most of these steps are done with a single pull of a lever. I would recommend a single stage O type press for a beginner. If there are any questions that the mannual can't answer we will answer them here.