I am looking at the same dilemma right now. OK, after not using carbons for 10 years, I bought a half dozen tapered carbons. I really don't want to permanently epoxy the inserts if I don't have to. Manufacterer suggests epoxy.

In order to remove the nocks (they are hot glued on an aluminum insert), the manufacturer suggests dipping the nock end in boiling water. They state that this will not effect the carbon. Now water boils at 360 degrees and hot melt melts at about 250 degrees.

So when removing the inserts, why not just heat up a screw in field point put it in the shaft andwait for the glue to meltand just remove it. You wouldn't have to put direct heat on the shaft at all. I have done this with aluminum all the time. Anyone try this.