HuntingNet.com Forums - View Single Post - Bore Cleaning Question
View Single Post
Old 03-01-2007 | 06:39 PM
  #12  
Rammer's Avatar
Rammer
Nontypical Buck
 
Joined: Aug 2005
Posts: 2,862
Likes: 0
From: South Dakota
Default RE: Bore Cleaning Question

ORIGINAL: 48thguns

ORIGINAL: Rammer

I just never clean the bores on my rifles and they all shoot extremely well! hehehe

My 7mag Browning I have owned since I was 12 years old, I will turn 24 in 29 days or so, and I have cleaned the bore on it once, and it will put 3 shots under .5" using handloads. The rifle has around 1,000rds put thru it. It is to the point though where I think I will give it a good scrubbing, just for good measure.
Hello Rammer. Impossible. That's my take and I'm sticking with it period. It sounds like a great rifle and I'm sure it is. however, the grooves have to be loaded with copper and there is no way it can be sub MOA...none. zippo. Go out and shoot a group right now and come back on the forum and say that it shoots MOA at 100 yards. IMHO, impossible, and I don't care what kind of loads. Regards, Rick.
I guarantee your right as well. There is a 40 mph sustained wind and snow. I don't know if its even possible to see 100 yards right now! LOL


Here is when I first sighted my rifle in before I left to go antelope hunting. 140gr Nosler Accubond with a max charge of RL22. The first two shots were the 2 grouped to the left, I then cranked my scope over and shot the 3 shot group. This was done at a lasered 115 yards. The 3 shot group measures .466"


Rammer is offline  
Reply