Try as I might I cannot see a raised area on my 2006 cams. That look flat as can be all the way to the point I can no longer see. I can see the silver circle of the bearing and they are defiantley rubbing outside of the silver circle, rubbing on the silver part of the cam.

What I do see is a gap on one side of the axle anlged and then flush on the other side of the axle (semi- twisted). I cannot get a piece of dentle floss between the cam and the cap in the locations where it rubs the cap.

Will this matter in time, I dunno.

Looking tonight I noticed my cam is less than 1/16" away from the actual limb at rest. I don't remember it being this close, but never paid too much attention.

Time will tell....