I went back over it totally re-setting it up Saturday. I throughly cleaned the magnets, got a few black specks off of it. Then I cleaned the razor using a q-tip, got a bit of brown surface rust from it. I sat the base back on the table top and noticed a bit of play so I examined the base and found some paint runs that was causing a very slight shifting of the base. THAT just wouldn't do so I razored them off then sanded the area below the lil' cast feet. After all that and a few other things, I re-calibrated it and THINK I am holding to less then .3 gr variance. This I can live with for a bit as I am loading well under max till I get the hang of things. I still have to re-calibrate whenever I change load amount, i.e. 44gr to 45 gr or the difference exceeds 1 gr more. Not a biggie, even though annoying, I'm more fond of my fingers and eyes then concerned about my spare time. Monday I will still be calling Lee and next payday I have intentions of buying something else, Redding or Lyman off of Ebay since the prices are about right.
Thanks all for the advice, hopefuly Lee will step up on this one and get it back to 100%.