Well, after 3 Bowtech's without an issue, I finally run into a minor problem with my new 07 Allegiance. I noticed it while doing a once over on the bow the other day after shooting. Apparently, the top cam was very close to the limb and at one point did come in contact. The mark is extremely small and didn't obviously hinder the bow in anyway. Who knows how long I shot it this way. Comparing the top cam to the bottom, the top is almost touching. Its so close, I tried to slide a peice of lightweight fleece between it for comparison and you can't.

So, on the phone with Bowtech I went. I explained it to the tech and he agreed it definitely wasn't right and to take it back to my dealer. My guess is has something to do with the bearings in the cam. The cam looks square with the limb, just slide to one side more than the bottom.

I sure hope thats all it is because good lord did I shoot this bow well.

I have complete confidence in getting this resolved. Sounds as though the parts will be here in a few days and I should be back in business shortly. Upon taking it to the dealer and having a conversation with him he said he had one issue like this last year with a Tribute. This out of approximately 250 Bowtech's sold last year. Not too bad if you ask me.

I'll update this post when I get word from the shop. Just wanted to pass this along.