HuntingNet.com Forums - View Single Post

12-31-2006 | 06:12 AM

#9

DBVixen

Joined: Apr 2006

Posts: 13

Likes: 0

From:

RE: NAP Quick Spin vanes

Well here is the 1.5 inch Quick Spin sitting next to my 2 inch Blazer vanes
20 inch Gold Tip Laser II, 125 grain field tip head, aluminum front and rear inserts, total 363 grains, 13.2 FOC.
http://i7.photobucket.com/albums/y267/Mudball/QuickSpin.jpg
No problems so far and cant see any sign of where the edge of the vanes are rubbing the rail. Im going to stop testing until I get a scope again maybe this spring or summer. I can test more accurately with a scope and Im going to build a better rest to shoot from. The factory peep sight is great but a scope is much better. I didnt readjust my factory sights because they are a bugger to readjust and its already sighted in for my heavier brass inserted bolt Im currently using.
Any way there is no difference (or not noticeable) between the point of impact between the quick spin and blazers. The points of impact stayed the same for both up to forty yards with field tips. If the the quick spins was spinning too much then I believe they would slow down causing the bolt to drop its point of impact but that was not the case. That might be the case if I was to use the suggested larger quick spin vanes and then it might make a difference. The problem with these smaller 1.5's is that I thought they wouldnt control well enough. When I tried the Montec G5 125 grain head with the 1.5 quick spins the point of impact was the same.
The 1.5 Quick Spins only weigh 3 grains each...pretty light. I will have to try more accurate results after I get a scope. But I was impressed so far

Reply

0