ORIGINAL: sabotloader
Pglasgow
No it would probably not - but how are you going to know if you compress the glass to the correct point or equal thickness on each lug - you might come up a bit uneven between lugs or you might end up with an air pocket... just wondering - not condemming.
But I freely admit I am self-condemned as ignorant on this subject. Without your comments I am completely ignorant, not that in some amazing defiance of Murphy's Law, I could I suppose, get it right with out the hard earned experience of others, finding myself, a freshlyfallen piece of toast, lying butter side up. You are bringin up points now I haven't considered so thank you.
So do you just think I shouldonly trim the stock to float the barrel?
Nother question - as you look at those lugs for my Omega you can see there is very little reinforcement to the front or the rear - outside the pocket. Infact myOmega fractured the pocket on the inside.I am going to re-enforce those areas also..
I see that. I think that would be a good idea too.